This form has a dual purpose, it enables both:

• Contracts to be set, and/or
• Predictive Assessments to be made.

For certain fees for which an applicant will be liable if they take up a place in a specified course. These tasks are achieved by initiating online processes from within the form.

In addition, it displays Tuition Fee Contracts that have already been established automatically. For applicants in designated Admission Categories, this can be done as a part of Pre-enrolment in courses.

Contracts and Fee Assessment

Contracts represent an agreed rate for specified Fees. They are made between an applicant/student or their sponsor and the institution. Usually this rate is agreed for a definite period. When contracts are initiated through Admissions (as opposed to using FINF2900, Maintain Contract Fee Assessment Rates) the rate used is selected automatically from the standard rates recorded for the fee in the Fee Period in which the contract is due to Start. The duration of the contract is set to the normal duration of the course. Fee Assessment periods are also associated with the contract Fee Assessment rates. 

Assessment of fees for which an applicant/student will be/is liable are made for each Fee Period by running the Fee Assessment routine, FINJ3500. When this job is run as a Predictive Assessment from this form, not all fees can be assessed (see Rules/Notes, below). Assessment transactions created by the job are displayed against the relevant future Fee Period in the Manual Fee Assessment form, FINF3610.

It is most likely that a Predictive Assessment will be run after establishing a contract. However, either of the two processes can be run independently. Both processes rely on an UNCONFIRM Student Course Attempt or attempts having been created through Pre-enrolment.

Where applicants do not take up the offer of a course at the institution, Predictive Assessments can be reversed - see ADMJ3850, Clean-up Unconfirmed Student Course Attempts.

Further information

Both processes relate primarily to the Student Finance Subsystem. Background information about them can be found in the section Understanding Student Finance, specifically under Individual Sponsorship and Contracts and Assessment and Invoicing. Further links from there lead to other relevant forms and jobs.

Information about alternative processing methods and setup is given in the Student Finance Specialist Overview, under Contracts/Predictive Assessment at Admissions. A discussion of rates as a component of Fee Calculation in the assessment routine is given in the Calculations section.

Access

This form is accessed through ADMF3000 via the Application button (bottom block), then through ADMF3240 via the Fee Details button (bottom block).

The Student Course Attempt block contains:

• Person ID
• Sex
• Date Of Birth
• Course Version
• Location Code
• Attendance Mode
• Attendance Type
• Calendar Type
• Commencement Date
• Fee Category
• Student Status

  Button

  • Fee Assessment (FINJ3500)

The Fee Assessment Rates block contains:

• Fee Type
• Charge Rate
• Currency
• Contract Rate
• Contract Start Date
• Contract End Date
• Location Guide
• Att Type
• Att Mode
• Low Norm Rate Over check box
• Calendar Type
• Start Date
• End Date
• System Fee Trigger
• Fee Trigger Category
• Charge Method Type

  Button

  • Set Contracts

Context information from ADMF3240 is displayed in the Student Course Attempt block. Queries cannot be performed in this block.

Initiate a Predictive Fee Assessment for the applicant and course shown, by selecting the Fee Assessment button in this block.

Rules/Notes:

Predictive Fee Assessments cannot be made for Student Contribution Amount (System Fee Type = COMSUPPORT (HECS)) or for fees with a PERUNIT Charge Method. Institution fees are only considered if no other Course Attempts are liable.

The Fee Period or periods for which Predictive Assessments are made are those active at the proposed Commencement Date for the Course Attempt (carried forward from ADMF3240 as context data in this block).

The Effective Date at which transactions are created through Predictive Fee Assessment is set to the value of the Commencement Date.

To assess fees with a Charge Method of EFTSL or CRPOINT, default values for Full-time and Part-time (as nominated by the applicant) are used. EFTSL defaults are established in. Credit Point defaults are calculated from the EFTSL defaults by multiplying EFSTL by standard Annual Load for the course (given in CRSF1210).

For example, if the default part-time value is 0.25 EFTSL and the standard Annual Load is 8 Credit Points, the Credit Point value of the applicant's Course Attempt is assumed to be 2 Credit Points (0.25 * 8 = 2).

Note: Predictive Fee Assessment amounts are based on the default values for a nominated Attendance Type, therefore an Attendance Type other than UNDEFINED must be specified.

Use the Fee Assessment Rates block to:

• View any existing contracts established automatically as a part of offering a course place to an applicant.
• Set contracts for any other fees displayed in the block.

Fees other than Student Contribution Amount and INSTITUTN fees can potentially be established as contracts, and hence shown in this block, if they:

• Are liabilities of the applicant's Fee Category in the Fee Period or periods active at the applicant's proposed Commencement Date.
• Have a Trigger matching the selected course for the applicant (see Triggers in the Student Finance Specialist Overview). Note that Unit and Unit Set Triggers and combinations are not applicable.

Existing Contracts

Contracts for Tuition Fees only can be established automatically when Pre-enrolment occurs as a part of the Admission Process. If the FEE-CNTRCT Admission Process Step is in effect, this occurs when an Outcome Status of OFFER or COND-OFFER is recorded for the Course Application in the form ADMF3240, from which this form is called.

Existing contracts are distinguished by having values in the Contract Rate, Contract Start Date and Contract End Date fields.

Setting Contracts

For those fees with the standard charge rate shown, a contract at that rate can be set by:

• highlighting the fee, and
• selecting the Set Contract button.

Matching Course Attributes

Whether contracts are set automatically or by using the Set Contract button in this form, they can only be established if the relevant Fee Liabilities have a standard rate recorded in FINF2853 that matches the applicant's nominated course attributes. Attributes might be any of Location Code, Att Type, Att Mode or Student Status, depending on the Fee Type. Refer to the section on standard rates in Student Finance Special Topics.

If the Charge Rate field is blank, then no matching rate has been found. Possible actions are:

• To record an additional standard rate in FINF2853, or
• To broaden the criteria of an existing rate and re-run Pre-enrolment, or
• To set the Contract Rate as a 'one-off' in FINF2900.

Displayed Values

These values cannot be altered in this form.

Queries can be performed on Fee Type, Calendar Type (Fee Period), Start Date, End Date, System Fee Type, Fee Trigger Category and Charge Method Type (use UPPER CASE).

Notes on derivation are given in the opposite column.

Rules/Notes:

Contract Rates cannot be established for fees:

• With a System Fee Type of COMSUPPORT (HECS), or
• A System Fee Trigger Category of INSTITUTN and such fees are not displayed in this form.

A Fee Category and Student Status should be assigned to the applicant in ADMF3240 (using Fee Assessment in the T-list).

If changes are needed to contracts established in this form, they must be made in FINF2900Maintain Contract Fee Assessment Rates). Changes are reflected in this form.

The Contract Rate established here is used if the Effective Date for running the Fee Assessment routine falls within the period specified for the contract.

The exception is where the rate recorded in FINF2853 will apply if this is lower than the Contract Rate at the time the assessment is made. See Lower Normal Rate Overridecheck box, set in FINF2900.

Contract Rates cannot be established for a student course attempt that has a Govt Course Cohort defined with the date range of the course cohort overlapping with the proposed contract date range.

Fee type. Fee types shown are those that:

• Are recorded as liabilities of the applicants Fee Category.
• Have an active Fee Period at the Commencement Date shown in the previous block.

Charge Rate. The rate depends on a match between the applicant's course attributes and those recorded against the assessment rates in FINF2853 for the relevant fees.

Currency. The applicable currency is recorded against the Fee Category in FINF2800(Maintain Fee Categories).

Contract Rate. This will the same as the Charge Rate, unless amended via FINF2900 (Maintain Contract Fee Assessment Rates).

Contract Start Date. This is set to the Start Date Alias Instance of the Fee Period associated with this fee.

Contract End Date. This is derived from the expected Completion Date shown in ADMF3240.

Location Code, Att Type and Att Mode have a value if a rate is specifically established in FINF2853 that matches the applicant's nominated characteristics for the course.

Low Norm Rate Over. The Lower Normal Rate Override check box can be set in FINF2900.

Calendar Type. This is the Fee Period in which the liability is operating.

Start and End Dates. These are instance of the Start and End Date Aliases set up for the Fee Period.

System Fee Type and Fee Trigger Category. These are recorded against a fee in FINF2100. Only fees with a Fee Trigger Category of COURSE can be established as contracts through Admissions.

Charge Method Type. The charge method may be recorded at Fee Type level in FINF2100 or at Fee Liability level in FINF2800.